Technical requirements and parameters: 1, Dimensions: 8.35 × 0.61 × 1.22 (L × W × H) m. 2, the heating and drying method: three temperature zone temperature control, stainless steel heat pipe heating and drying. 3, drying temperature: room temperature ~ 130 ℃ continuously adjustable, temperature control accuracy ± 3 ℃. 4, Power: Three-phase AC 380V ± 10%, 50Hz. 5, power: 25kW. 6, blade method: casting box the way; 7, feeding mode and casting speed control: the use of nitrogen from the pressure cooker pushed out by nitrogen pressure and strip casting speed transmission to adjust. (Binder nitrogen source is prepared by the purchaser) 8, flow film thickness and uniformity: by adjusting the micrometer screw and adjust the gap casting knife to control the thickness of 0.030 ~ 0.150mm, depending on the film thickness of the slurry flow properties or continuously adjustable, it is possible to do ≥0.11mm, ≤0.30mm. 9, the flow film width: 100 ~ 190mm, according to production process requirements, the replacement casting knife and cast box, select the appropriate width, commonly is 190mm. 10, transmission speed: the speed control motor speed continuously adjustable strip 200 ~ 2000mm / min, the strip offset ± 2 ~ ± 4mm. 11, with the slit diaphragm and automatic transmission apparatus, cutting film length accuracy: ± 0.5mm, diaphragm conveyor speed is adjustable. 12, electrical control: Use intelligent temperature controller, solid state relays temperature control mode.